Cluster – LED Wedge
Thanks go out to Christopher Whelpley for putting these directions together. He also provided the pictures that are numbered with notations, etc.
If you want to do the LED strip light addition you can find directions here. I only did the LED Wedge upgrade.
Christopher likes to use his 100 piece Security Bit Set from Harbor Freight ($10) with 1/4″ ratchet for jobs like this. Has all you need to complete this task.
*Step 1. Use #5 Hex to remove the 3 bolts that hold the bezel to the tank.
*Step 2. Carefully lift away from tank and unplug both harness plugs and move to table/bench for better work area.
*Step 3. Use #2 Phillip’s to remove the 3 screws that hold the cluster into the bezel, and separate.
*Step 4. Remove the 3 spacer washers so they dont get lost and pop out the bottom grommet (carefully)
*Step 5. Remove the 5 brass, #2 Phillip’s screws on back and 1 on the face side, along with the 2 small #0 Phillips screws and wire grommet ring.
*Step 6. BE EXTRA CAREFUL HERE… Carefully separate the black and white pieces while feeding rubber harness grommet and plugs through the back of the white piece. You can now change them by giving them a 1/4 turn to the left and pull out. Replace with T3 NEO LED wedge. Before reassembly, plug harnesses back in to make sure the lights illuminate, if some dont, remove them and turn 180° and reinstall.
Step 6.2. You can now change them by giving them a 1/4 turn to the left and pull out. Replace with T3 NEO LED wedge. My wedges went in a little hard so be careful when inserting them I used needle nose pliers to turn them.
Before reassembly, plug harnesses back in to make sure the lights illuminate, if some don’t, remove them and turn 180° and reinstall.
*Step 7. Reassemble…you’re almost done!
*Step 11. You may have to fight with these… when reassembling the bezel to the tank to line up all 3 pieces and holes.
*Step 12. Have fun, ride safe!!
Sincerely: one of you’re up and coming gurus –Christopher Whelpley
This is what mine looked like before and after.
